Towards Using a Multi-material, Pellet-fed Additive Manufacturing Platform to Fabricate Novel Imaging Phantoms: data

The attached raw data are presented in figures within the manuscript:

Fig 4: Measurements of the built parts relative to the aspired, digital design files. Data defines the length of each border, for the 3 parts built from each material, across teh 4 infill densities. 

Fig 5: Precision of the built parts, with data describing the relative measurements across the 3 materials.

Fig 6: Data derived from micro computer tomography, describing the relative density of each part relative to the density prescribed during the manufacturing process.

Fig 7: The Hounsfield Unit of each part, derived using a clinical computer tomography scanner.  This demonstrates how the HU value can vary across the parts, most likely due to the changes in parameters presented in figures 4 - 6.

Research results based upon these data are published at https://doi.org/10.1080/03091902.2023.2193267